Vinyl Replacement Windows

Do it yourself Questions - If Your Bound & Determined
Post Reply
Message
Author
jd438
Posts: 1
Joined: Mon Nov 02, 2015 1:49 pm

Vinyl Replacement Windows

#1 Post by jd438 » Mon Nov 02, 2015 2:02 pm

I looking at project to replace my current single hung vinyl windows with new replacement windows. I would like to leave my current interior trim intact. I have had two different window installers and of course two different courses of action. One would be to remove the window and exterior trim and install a new construction window. How can they shim the window properly without removing trim?
Second would be to cut existing window out and install a replacement window.
Someone has replaced 3 of the windows and it looks like they took out the old window and extended the jam from the interior to the exterior and then placed the replacement inside the opening, I would be replacing these as well to match.

Any suggestions? I have done new constructions, but have not tried the installation of replacements. I've been told it was easier, but I am scratching my head on the different methods.

User avatar
Windows on Washington
Posts: 4286
Joined: Fri Oct 27, 2006 11:23 am
Location: DC Metropolitan Area-Maryland/Virginia/DC

Re: Vinyl Replacement Windows

#2 Post by Windows on Washington » Tue Nov 03, 2015 5:59 am

Both should be able to preserve the interior trim to be honest and both are suitable options.

Just depends on how and what both are deploying as part of the install in terms of which will be better. I have seen new construction installs done wrong and look terrible just as I have seen inserts done wrong and look terrible.

TheWindowNerd
Posts: 1644
Joined: Fri Apr 17, 2009 3:05 pm
Location: SE PA & NJ; DFW/Metroplex

Re: Vinyl Replacement Windows

#3 Post by TheWindowNerd » Thu Nov 05, 2015 6:53 am

DH with a fin can be done from the exterior. I prefer to do them without a fin if I am leaving the interior casing up, so that I can shim more easily and foam correctly.

Post Reply