Looking forward to some expert advice
I’m going to replace this window during a bath remodel. The new window is an insert fairly straight forward install I suspect. The challenge is removing the existing window
I was told to use a multi tool and cut the frame free of the flange from the inside. You notice I removed one tile to take a look. It looks doable and makes sense but I’d like to hear others advise.
I also see from the outside it appears the frame does extend into stucco about a 1/4” so I suspect I will have some stucco damage from cutting the flange
What do y’all think
Metal half round frame in stucco
-
- Posts: 3
- Joined: Mon Jan 08, 2024 12:21 pm
-
- Posts: 929
- Joined: Fri Nov 19, 2004 10:44 am
- Location: South Jersey, Delaware, Philadelphia area
Re: Metal half round frame in stucco
Heat gun or torch to loosen glass from glazing putty of death that holds glass to aluminum frame first. Gloves and safety glasses. Sharpen 3" tapered flexible putty knife. I sharpen the edges and side with a mill file. You can also utilize a multi oscillating tool with a scraper blade or old blade with no teeth. Most folks with leave the flange in so you don't crack or damage the stucco although some will remove as well.
-
- Posts: 3
- Joined: Mon Jan 08, 2024 12:21 pm
Re: Metal half round frame in stucco
So I have to remove the glass panes first. Ugg.
-
- Posts: 929
- Joined: Fri Nov 19, 2004 10:44 am
- Location: South Jersey, Delaware, Philadelphia area
Re: Metal half round frame in stucco
You don't have to. However, it has snap in glazing beads that come loose without a lot of trouble it may make sense and be safer. Some of that extruded aluminum on those metal windows are kind of thick in regards to the nailing flange unlike the lighter gauge stuff on Pella type window. You may need a sawzal for the cutting?
-
- Posts: 3
- Joined: Mon Jan 08, 2024 12:21 pm
Re: Metal half round frame in stucco
I’m getting quotes for someone else to do it lol. So far from 250-350 and another for 475. I figure a pro could do this in 3 hrs or less.Delaware Mike wrote: ↑Mon Jan 08, 2024 10:30 pm You don't have to. However, it has snap in glazing beads that come loose without a lot of trouble it may make sense and be safer. Some of that extruded aluminum on those metal windows are kind of thick in regards to the nailing flange unlike the lighter gauge stuff on Pella type window. You may need a sawzal for the cutting?